Crema Joe WayCap One Pack (Dolce Gusto®)
The Crema Joe WayCap One Pack (Dolce Gusto®) is an eco-friendly, sustainable and economical alternative to the disposable coffee capsules used in Dolce Gusto®* coffee machines. Made from quality stainless steel, it features a silicone lid and has been constructed to last a lifetime.
Created to help reduce waste, this capsule can be used with your preferred coffee and is easy to top-up with the included WayCap dock and tamper. It also comes with two reusable stainless steel filters – each suited to a specific grind size – and the components are easily rinsed clean in water.
The WayCap One Pack contains:
1 Stainless Steel Reusable Capsule
2 Stainless Steel Filters
Please note: Coffee grounds are not included.
Made in Italy. Low to no plastic.
Before using your FeePod capsule in your coffee machine, descaling is recommended to ensure that the brewing pressure is normal and to assist with optimal performance.
Step 1. Place the strainer into the pod
To brew lungo, place convex side up. To brew espresso, concave side up. Next, place in the paper filter if brewing tea or very fine coffee grounds. The paper filter may also assist in brewing a more intense espresso.
Step 2. Fill with the capsule with coffee and tamp
Fill with one level scoop of ground coffee, using the provided scoop provided with your pack. Tamp down to the measuring line using the base of the scoop or tamper. Repeat if the tamped coffee does not reach the measuring line. Please note: Over-filling or under-filling may cause the cover to open during the brewing process.
Step 3. Click the desired steel filter into the capsule lid. For very finely ground coffee, a filter with more slots is recommended. For a courser grind (more watery coffee), a filter with minimal slots is best.
Step 4. Place the lid on the capsule.
Step 5. Place the DGpod into the capsule holder of the machine.
Align the front of the cover (where the small hole is located) with the centre of the machine's capsule holder.
If the machine lever doesn't close, double-check that you have aligned the capsule correctly.
Step 6. Adjust the water level of the machine, and brew
Please note: After brewing, wait at least 1 minute for the components to cool before pulling the capsule holder from the machine to avoid damaging the capsule cover.